Remember! Ten safety operation Precautions for Road rollers

When in operation, the roller should start to vibrate first, and the internal combustion engine should be set to medium speed first and then adjusted to high speed.

2. When changing speed or direction, the machine should be stopped first. When changing speed, the speed of the internal combustion engine should be reduced.

3. It is strictly prohibited for the roller to vibrate on a solid ground.

When compacting soft subgrades, it is necessary to compact 1 to 2 times without vibration first, and then compact with vibration.

5. When rolling, the vibration frequency should be kept consistent. For the vibratory roller that can be adjusted, the vibration frequency should be set first before operation. It is not allowed to reduce the vibration frequency when there is no vibration.

6. The adjustment of the reversing clutch, the starting clutch and the brake should be carried out after the main clutch is disengaged.

7. When going up or down slopes, do not use the fast gear. When making sharp turns, including when articulated vibratory rollers are making small turns and circling for compaction, it is strictly prohibited to use the fast gear.

8. When the roller is traveling at high speed, it must not engage and vibrate.

When shutting down, first stop the vibration, then place the reversing mechanism in the middle position, put the transmission in neutral, and finally pull up the handbrake lever. Let the internal combustion engine idle for several minutes and then turn it off.

10. Other operation requirements shall comply with the regulations for static pressure rollers.