Do you know the correct operation steps for road roller construction?

The roller must be started when there are no obstacles or people in front of, behind or on either side of it.

2. When changing the forward or backward direction of the roller, it should be done after the rollers have stopped. It is strictly forbidden to use the reversing clutch for braking.

When the roller is working close to the edge of the embankment, a necessary safety distance should be left according to the height of the embankment. When rolling over mountain roads, it is necessary to roll from the inside to the outside. When going uphill, gear shifting should be done after braking. When going downhill, it is strictly forbidden to shift gears and coast.

4. When two or more road rollers are operating simultaneously, the distance between them in front and behind shall not be less than 3 meters. When they travel in a single file on a slope, the distance between them shall not be less than 20 meters.

5. Vibratory rollers shall also comply with the following regulations:

A. Vibration start and stop must be carried out when the roller is in motion. Vibration is strictly prohibited when traveling on hard roads.

B. When compacting soft subgrades, it is necessary to first compact 1-2 times without vibration, and then compact with vibration.

C. The adjustment of the reversing clutch, the vibration-starting clutch and the brake must be carried out after the clutch is disengaged. Do not use the fast gear when making sharp turns. It is strictly prohibited to adjust the vibration frequency before vibration has started.