Home > News > Maintenance
Maintenance
Standards for oil deterioration in hydraulic systems of construction machinery
Notes on Project Standard valuesWhen the viscosity changes by (10-15)% and three
Notes on Project Standard values
When the viscosity changes by ±(10-15)% and three of the indicators exceed the standard value, new oil should be replaced
Acid value (mg(KOH)/g) ±(20-30)%
Moisture content (volume) > 0.15%
Particulate impurities shall not be lower than the specified contamination grade
The specific gravity changes by ±0.05
Rust test: Rust
Corrosion test corrosion
The emulsification condition has been emulsified
The state of the oil changes from boiling to blackening
Related articles
- 1.36 degrees per kilometer, a new model for the operation of new energy heavy-duty trucks driven by
- A must-buy in 25 years! This 1.5-ton double-lift electric forklift is worth having
- Accelerate the cultivation and opening of scenarios, and empower the value transformation of scenari
- XCMG's strong support for energy supply security!
- Troubleshooting methods for the "equal gear" fault of the TY220 bulldozer
- Troubleshooting for insufficient engine power of Caterpillar CAT3512
- Analysis and Control Methods of Oil Leakage Phenomenon in Gear Pump Oil Seals of Loaders
- Solutions to the problems of weak power in loaders and high oil temperature in torque converters
- Fault Analysis and Elimination Methods for the Hydraulic Transmission System of Loaders
- The "observation, olfaction, touch, smell and palpation" analysis method for loader faults
