What are the precautions for the double specific gravity cleaning machine

When using a dual-density cleaning machine, attention should be paid to multiple aspects such as the working environment, operation norms, equipment maintenance, variety replacement, safety protection and fault detection. The following is a detailed explanation:

Working Environment and Foundation

The cleaning machine should be installed on a flat and solid foundation to ensure long-term stable operation. When working indoors, the convenience of dust removal should be taken into consideration. When working outdoors, a sheltered area should be chosen and the machine should be placed facing the wind. When the wind speed exceeds level 3, a wind barrier should be considered for installation.

Sufficient space should be left around the equipment to facilitate the disassembly and adjustment of the countertop.

Operating Specifications

Before starting up, it is necessary to check whether all the bolts are tightened, whether the tightness of the transmission belts and chains is appropriate, and whether sufficient grease has been added to the lubrication points.

The start-up sequence should be the fan, the vibrating screen motor, and the elevator. When shutting down, the sequence should be reversed to avoid intermittent feeding or prolonged feeding.

During the operation, it is necessary to pay attention to the stability of the feeding amount to avoid the material layer being too thick or too thin, which may affect the cleaning effect.

Equipment maintenance and upkeep

After each shift's work, cleaning and inspection should be carried out in a timely manner to eliminate faults and replace damaged parts.

Regularly lubricate all parts of the machine. The transmission gears should be filled with engine oil or grease.

When not in use for a long time, it should be properly stored. Before storage, the machine needs to be cleaned and comprehensively maintained.

Variety replacement and clearance

When changing varieties, all residual grains and impurities in the machine must be thoroughly removed to prevent the varieties from being mixed.

When removing the residues, the feeding hopper gate should be closed, the seed holding trough of the grain selection cylinder should be turned over, and the air intake channel should be closed. Let the machine idle. After all the residual grains have come out, stop the machine and remove the screen frame, screen plates and other components for cleaning.

Safety protection

When working, a protective cover must be properly installed. It is strictly forbidden to put hands into the feeding port or moving parts.

The electrical control section should have multiple protection functions to ensure safe electricity usage.

The ground power line should be made of cable and meet the insulation requirements. The body should be well grounded.

Troubleshooting and Debugging

If any abnormal operation of the equipment or poor cleaning effect is found during the operation, the machine should be stopped immediately for inspection and debugging.

When debugging, sufficient materials to be processed and receiving containers should be prepared to ensure continuous debugging.

It is necessary to pay attention to the influence of adjusting parameters such as feeding rate, air volume, vibration frequency and inclination Angle on the sorting quality.