Maintenance
Analysis of Common Faults of Gear Pumps for Compaction Garbage Trucks
1. Reasons for the oil pump not discharging oil or insufficient flow
The pump doesn't rotate.
The oil suction pipe or oil suction filter is clogged
The amount of hydraulic oil is too low
The internal components of the pump are worn or damaged
The seal is damaged.
Exclusion method
The spline of the pump is damaged or the power take-off cannot be engaged
Analyze, inspect and repair, and clear blockages
Add hydraulic oil to the specified height
Replace or repair replacement
2. Reasons for high noise and large pressure fluctuations
The oil suction pipe or oil suction filter is clogged
There is a large amount of air in the oil circuit
The internal components of the pump are worn or damaged
The oil is contaminated or emulsified
Exclusion method
Analyze, inspect and repair, and clear blockages
Exhaust
Replace or repair
Change the hydraulic oil
3. Causes of abnormal fever
There is a large amount of air in the oil circuit
The amount of hydraulic oil is too low
System blockage
Exclusion method
Exhaust
Add hydraulic oil to the specified height
Analyze, inspect and repair, and clear blockages
Related articles
- Analysis of the Reasons for Insufficient Power Output of F6L913 Diesel Engine
- Analysis of Factors Affecting the Performance of Construction Machinery
- A Brief Analysis of the Median Function of Directional Control Valves
- Faults and Analysis of the Rear Axle Differential of ZL50 Loader
- Prevention and Judgment methods of Common Faults in Storage Batteries
- A Brief Analysis of the Advantages and Disadvantages of Loaders
- Diagnosis and Elimination of High and Low Speed Disengagement Faults of ZL30
- Analysis and Solutions to the Problem of Damage to the Working Device of Loaders
- Analysis and Fault Diagnosis of Exhaust Gas Color of Diesel Engines in Construction Machinery
- Fault Analysis of a Hydraulic Oil Cooling System
