Selection and Maintenance of the New Fruit Picker

When choosing a fruit sorter, the standards vary. Please pay special attention to the following points:

1. Sorting speed. Generally, the speed of the fruit sorter per hour can be adjusted according to your requirements. There are models that can sort 1 ton per hour, 2 tons per hour, and 5 tons per hour. You can directly inform the salesperson of your requirements.

2. Sorting grades, that is, classification. There should be at least 3 grades and no more than 9 grades. You can set them arbitrarily.

3. Sorted fruits. The salesperson usually asks you about the type of fruits to be sorted, whether for vegetables or fruits. Make adjustments based on these details.

4. If you care about the appearance, you can also consider it.

5. Choose the third-generation new fruit sorter. The quality and after-sales service are guaranteed. Maintenance and upkeep

Regarding the problem of the leakage protection device of the fruit sorter tripping: Reason:

1. The leakage switch is damaged or the electrical appliance has a grounding short circuit. The neutral line on the load side and other circuits are mixed.

2. This is caused by the unreasonable classification and segmentation protection of the leakage switch.

3. Faults in the lines, such as leakage short circuits or incorrect wiring, can all cause the circuit breaker to trip.

4. The switch is overloaded, and the rated current of the switch does not match the load.

5. The live wire on the load side of the switch is grounded, and the grounding of the neutral line on the load side of the leakage switch causes the circuit breaker to trip. Solution

1. The leakage current and action time of the selected leakage switch should be greater than those of the upper-level leakage switch.

2. Check if the leakage switch is damaged. If it is, replace it.

3. Inspect the insulation of the load side lines of the leakage switch and check if the sensitivity of the upper-level leakage switch is too high.